Znyx Networks bh5700 Manuale Utente

Only the GARP normal registration mode is currently supported.

Multiple instances of zgmrpd may run concurrently provided the targets are unique. However, 
zgmrpd cannot run concurrently with zsnoopd. See zsnoopd.

-d <level>
Sets the level of debugging output required by zgmrpd. The 

default level is zero (0). Setting the debug level higher 
produces more output. Five (5) is currently the maximum output 

level.

-f

Run zgmrpd in foreground. Default is to run it in 

background.

-h <hostname>

Connect to remote host <hostname>.

-p <ppa>
Start zgmrpd on switch <ppa>. Default is 0.

-t <target>

Enable GMRP on the set of ports specified by the target, either a 
zhp or bzhp interface. There is no default. A target must be 

specified.

In the following example, zgmrpd starts a background task that enables the GMRP protocol for 
the ports in the zhp0 interface.  zgmrpd receives and sends GMRP packets, and updates the 
Multicast Table (MARL) accordingly. This background task continues throughout the life of the 
Layer 2 network, or until manually terminated.

zgmrpd –t zhp0

Once you run zgmrpd, use zmarl to display the contents of the MARL. zgmrpd deletes all 
entries in the MARL when starting up, and when shutting down. Manual changes to the MARL 
can be made while zgmrpd is running. However, all such changes will be deleted when zgmrpd 
is terminated. 

zconfig, zsnoopd 

Ethernet Switch Blade User's Guide

release  3.2.2j

page  296