Znyx Networks bh5700 Manuale Utente

the number of IP addresses as applicable. In the example below, the IP address is changed 
for the interface in the ifconfig command line of the script.

From:

ifconfig zhp0 10.0.0.43 netmask 255.255.255.0 broadcast 

10.0.0.255 up

 To:

ifconfig zhp0 193.08.1.1 netmask 255.255.255.0 broadcast 
193.08.1.255 up 

•

Adjust the number of zhp interfaces, that are added to the routing tables, depending on the 
number of VLANs you are adding for your network.  Include any other details, as 
applicable.

•

Run the OpenArchitect zsync command to save your changes. 

zsync

•

Reboot the switch. 

•

After rebooting, your switch works from your customized Layer 3 configuration.

An advanced networking configuration may require using the GateD software platform for 
deployment of Routing Information Protocols (RIP 1 or RIP 2) and Open Shortest Path First 
(OSPF) protocols. Once you’ve configured your Layer2 and Layer3 devices, start gated.

To use GateD protocol with the switch, you need to copy two files into the same directory as your 
Layer 3 configuration file. From the /etc/rcZ.d/examples folder, copy the example script file 
and its corresponding GateD configuration file (for example, S55gatedRip1 and 
gated.conf.rip1).

The example startup script executes the following commands (S55gatedRip1 is used as an 
example):

•

Starts GateD with Rip1 using gated.conf.rip1 as the configuration file:

/usr/sbin/gated –f /etc/rcZ.d/gated.conf.rip1

The GateD conf file specifies the following configuration commands:

•

Implements the passive function so GateD is prevented from rerouting information to a 
different interface if insufficient information is received. 

interface 10.0.0.43 passive

Ethernet Switch Blade User's Guide

release  3.2.2j

page 54