Znyx Networks bh5700 Manuale Utente
The pepd utility requires a PDP that has implemented the above RFCs and drafts. Until all draft
standards are approved, the certain COPS-PR data types will not be assigned OIDs. pepd uses
non-standard OIDs for the unassigned values.
standards are approved, the certain COPS-PR data types will not be assigned OIDs. pepd uses
non-standard OIDs for the unassigned values.
Using pepd
The pepd utility works by connection to a PDP, informing the PDP of its roles, and installing
any rules that the PDP has for those roles. Configuration information should be specified in a
configuration file, specified on the command line with the –f option.
any rules that the PDP has for those roles. Configuration information should be specified in a
configuration file, specified on the command line with the –f option.
pepd –f <full_path_and_filename>
A sample configuration file is listed below:
PDP address: 10.0.0.11
PDP port: 3288
PEPID: some-id
PEPID: some-id
Role-If: a zre1,zre2,zre3,zre4
where,
PDP address: The IP address of the PDP. Default is loopback (127.0.0.1)
PDP port: The destination port on which to open a COPS connection. Default is 3288.
PEPID:
The PEP Identifier
Role-If:
A mapping of roles to interfaces. The name of the role is followed by a comma-
delineated list of interfaces. Multiple role-interface mappings are defined through multiple Role-
If declarations.
If declarations.
Ethernet Switch Blade User's Guide
release 3.2.2j
page 72