Volvo 1997 850 Manuale Utente

1997 Volvo 850

 

 

  

 

 

 
There is a jack attachment located in the center on each side of the car. Position the jack on the bar in the 
attachment as shown in illustration A above and crank while simultaneously guiding the base of the jack 
to the ground. The base of the jack must be flat on a level, firm, non-slippery surface. Before raising the 
car check that the jack is still correctly positioned in the attachment . Raise the vehicle until both wheels 
on the side of the car where the jack is attached are lifted off the ground. Unscrew the wheel bolts 
completely and carefully remove the wheel so as not to damage the thread on the studs. 

 
Installing the wheel 

 
Clean the contact surfaces on the wheel and hub. Lift the wheel and place it on the hub. Make sure that 
you align the wheel with the guide stud on the wheel hub prior to installation. Install the wheel bolts 
crosswise (see illustration) and tighten by turning lightly clockwise. Lower the vehicle to the ground and 
alternately tighten the nuts to 81 ft. lbs. (110 Nm). Install the wheel cap (where applicable). 

 

file:///K|/ownersdocs/1997/1997_850/97850_601.htm (3 of 5)12/30/2006 10:14:22 AM