Volvo D13 Manuale Utente

Pagina di 51
Section 01: ENGINE 
PA1561 
10 
1.3.9 Oil Change 
 
WARNING 
A hot engine or engine oil can be dangerous. 
Serious burns can result from contact with a 
hot engine or oil. Take precautions when 
draining the oil. Wear gloves or let the engine 
cool down before draining. 
 
 
WARNING 
When draining the oil, use the proper tools 
and keep away as far as possible. Raise the 
elbow so the forearm is parallel to the ground 
to prevent oil running down the arm, causing 
burns. 
 
 
CAUTION 
Always dispose of all lubricants (motor oil, 
coolant, gear box oils, etc) and filters 
according to Federal or local regulations. 
Used oil disposed of in nature or waterways 
contaminates our drinking water and kills 
wildlife. 
 
 
WARNING 
Prolonged contact with used engine oil may 
be harmful. Use rubber gloves when handling 
used oil. Wash skin thoroughly if it comes in 
contact with used oil. 
It is important to drain as much oil as possible. 
Try to change oil immediately after driving, when 
the oil is warm. Always replace the oil filters 
when changing the oil. 
Component Capacity 
(L) 
Oil pan 
24 min - 32 max 
Engine block 
4.5 
Filters (3) 
Total oil fill (empty) 
42.5 
 
NOTE 
Since about 1 liter of oil remains in the engine 
after draining, approximately 38 liters will be 
needed for a complete oil change.
 
1.3.10  Oil Filters Change 
WARNING 
Hot oil can cause severe burns. DO NOT 
allow hot oil to contact the skin. When 
changing oil, wear protective gloves. 
 
CAUTION 
Volvo-branded oil filters are designed to 
provide the proper level of filtration and 
protection for Volvo engines. Filters that do 
not meet the same stringent requirements 
may cause unsatisfactory results. 
•  Clean around the oil filter housing and 
remove the filters using the oil filter 
wrench or the oil filter socket. 
 
FIGURE 4: OIL FILTER WRENCH 
•  Prefill the new oil filters with approved 
engine oil. Also, lubricate the filter gaskets 
with engine oil (1). Hand tighten the oil 
filters until they contact the sealing surface 
of the oil filter housing (2). Manually 
tighten the oil filters an additional ¾ to 1 
full turn (3).