Volvo D13 Manuale Utente

PA1561 

45 

2.16  POWER PLANT ASSY. INSTALLATION 

To install a power plant assembly, follow the 
same procedure as in "Power Plant Assembly 
Removal" except in reverse order, then proceed 
with the following: 

5.  Torque the power plant cradle mounting 

bolts to 190 lbf-ft (255 Nm).  

6.  If fan drive has been removed, reinstall and 

align as per Section 05 COOLING SYSTEM, 
under "Fan Drive Alignment".  

7.  Refill cooling system with saved fluid (refer 

to Section 05 COOLANT SYSTEM).  

8.  Once engine fuel system has been drained, 

it will aid restarting if fuel filters are filled with 
fuel oil (refer to Section 03 FUEL SYSTEM). 

9.  Start engine for a visual check. Check fuel, 

oil, cooling, pneumatic and hydraulic system 
connections for leakage. Test operation of 
engine controls and accessories. 

2.17 JAKE BRAKE 

Refer to both "The Jake Brake Troubleshooting 
and Maintenance Manual" and "Installation 
Manual for Model 797 Engine Brakes" for 
troubleshooting and installation procedures. 
They are annexed at the end of this section. 

2.18  ENGINE MOUNTS  

The power plant assembly on a vehicle powered 
with a series 60 engine is mounted to the cradle 
by means of rubber mounts. 

Two rubber mounts are used at the front of the 
engine while two others are mounted on each 
side of the flywheel housing (Fig. 23). 

It is recommended that new rubber mounts be 
installed at each major overhaul. 
 

 

 

 

01107