VIZIO TL-R480T Manuale Utente

 

Figure 5-3  LAN 

 

 - The physical address of the router, as seen from the LAN. The 

value can't be changed. 

 

Enter the IP address of your router in dotted-decimal notation (factory 

default: 192.168.1.1). 

 

 An address code that determines the size of the network. Normally 

use 255.255.255.0 as the subnet mask.   

   

a. 

If you change the IP address of the LAN, you must use the new IP address to login 
to the router.   

b.  If the new LAN IP Address you set is not in the same subnet, the IP Address pool in 

the DHCP sever will not take effect, until they are re-configured. 

c.  If the new LAN IP Address you set is not in the same subnet, the Virtual Server and 

DMZ Host may change accordingly at the same time, you’d better re-configure it as 
well. 

You can configure the WAN port parameters on this page. 

First, please choose the WAN Connection Type (Dynamic IP/Static IP/PPPoE/802.1x + 
Dynamic IP/802.1x + Static IP) to the Internet. The default type is PPPoE. If you aren’t 
given any login parameters (fixed IP address, logging ID, etc), please select Dynamic 
IP

. If you are given a fixed IP (static IP), please select Static IP. If you are given a user 

name and a password, please select PPPoE

.

 If you are not sure which connection type 

you use currently, please contact your ISP to obtain the correct information. 

1. If 

you 

choose 

the router will automatically get IP parameters from 

your ISP. You can see the page as follows (figure 5-4): 

 

- 14 -