Viking Huskylock 936 Manuale Utente

1~2mm

—50—

Lower cutter

Lowest position

Upper cutter

Set screw

 Unplug the machine.

1. Open the front cover (page 3) and free arm 

cover (page 8).

2. Remove all the lint with the brush from the 

accessory box.

5-3. Storage
1. When the machine is not in use, disconnect it 

from the power supply.

2. Cover the machine with the vinyl cover when 

you have fi nished sewing.

3. Store the machine so that it is not directly 

exposed to sunlight or humidity.

5-4. Replacing the lower cutter
Cutters are available as an accessory at your 
authorized Husqvarna dealer.

 Unplug the machine

1. Open the front cover (See page 8).
2. Disengage upper cutter and turn to lowest 

position.

3. Loosen the screw of the lower cutter and 

remove the cutter.

4. Mount the new cutter.
5. Re-position the upper cutter.
6. Turn the handwheel so that the needles are 

in their lowest position.

7. Make sure that the front edge of the cutter is   

1~2 mm lower than the cutting edge of the 
lower cutter.

8. Tighten the new cutter with the screw.
9. Always clean with the brush.

  

5-5. Lubrication
To make the machine run smoothly and quietly 
some of the moving parts must be lubricated 
once or  twice a month when using the ma-
chine normally and once a week when using it 
frequently. Always  remember to unplug the ma-
chine for service. Remove all excess oil before 
you start sewing to avoid  staining your project.