Ultimate Technology 600 POS Manuale Utente
Series 600 POS Keyboard
57
EXAMPLE 6.
This example programs key at top left-hand corner of keyboard (row 1, column A) as a primary
key that outputs the string "abCd" for MAKE.
1. Use the data in Appendix D to find the key code numbers for the A, B, C and D keys on the
101/102-keyboard. The key code numbers for the A, B, C and D keys = 31, 50, 48 and 33,
respectively.
respectively.
2. Convert key codes 31, 50, 48 and 33 to their hexadecimal equivalents. The key codes = 1F,
32, 30 and 21, respectively.
3. Program command = A0krcCxDxCxDx(C^xD^x)CxDx<CR> =
A0 P 1 CF D1 C2 D3 ( C0 D3 ) C1 D2 <CR>
Parameters same as shown for example 1, except () = left shift MAKE and BREAK.
This command sends the MAKE code for the "ab"; MAKE code for the left SHIFT; MAKE
code for "C"; then BREAK code for the left SHIFT followed by the MAKE code for the "d".
EXAMPLE 7.
This example programs key at top left-hand corner of keyboard (row 1, column A) as a primary
key that outputs the scan code "left CONTROL a" for MAKE and BREAK.
1. Use the key code data in Appendix D to find that the key code number for the "A" key. The
key code = 31.
2. Convert key code 31 to its hexadecimal equivalent. The key code = 1F hex.
3. Program command = A0krc[CxDx!]<CR> = A0 P 1 A [ CF D1 ! ] <CR>
Parameters same as shown for example 1, except [] = left CONTROL key MAKE and
BREAK and ! = define where BREAK code start.
This command sends the MAKE code for the left CONTROL; MAKE code for the "a" when
pressed; then after release of the key the BREAK for the left CONTROL. This allows more
keys to be typed in while the PC is under the influence of CONTROL. The ! causes all
codes remaining in the key macro to be sent on release of the key.
keys to be typed in while the PC is under the influence of CONTROL. The ! causes all
codes remaining in the key macro to be sent on release of the key.