Sony Microscope & Magnifier HDLA1500 Manuale Utente

15

Installation

When attaching the V-wedge shoe, taking the total weight 
of the adaptor, camera, studio lens and viewfinder, and the 
size of the pan and tilt head of the tripod into consideration, 
choose a position such that the unit will be mounted stably 
on the tripod.

Some tripods cannot be attached unless the feet and cable 
hanger are removed from the adaptor. 
Remove the feet and hanger to use such a tripod.

Attaching the stopper [1500][1507]

For use of the HDVF-9900 viewfinder in combination, 
attach the stopper supplied with the adaptor to the side 
panel of the adaptor.

• Be sure to turn off the camera power before mounting.
• If the camera is mounted with the power ON, the 

protection circuit of the adaptor will be activated. In such 
a case, unmount the camera from the adaptor, turn off the 
power, wait for more than 30 seconds, then mount it 
again.

Mounting procedure
While the figures of the adaptors in the following steps 
show the states where the studio lens and the large 
viewfinder are not attached, the camera can also be 
mounted after attaching the large lens and the large 
viewfinder to the adaptor.

For the HDLA1507, start from step 2.

Check that the camera lock lever on the front panel is 
in its upper position.

Bottom of the adaptor

Feet

Feet

Cable hanger

Example: To remove the feet near the V-wedge shoe

Feet

Remove the blind 
bush from the 
screw hole on the 
side panel.

Attach the stopper 
using the supplied 
screw.

[1500][1507]