SonicWALL TZ 190 Manuale Utente

With previous versions of firmware, it was necessary to write rules to the private IP 
address. This has been changed as of SonicOS 2.0 Enhanced. If you write a rule to 
the private IP address, the rule does not work. 

Go to the Firewall > Access Rules page and choose the policy for the ‘WAN’ to ‘Sales’ zone 
intersection (or, whatever zone you put your serves in). Click on the ‘Add…’ button to bring up 
the pop-up window to create the policies. When the pop-up appears, enter the following values:

Action: Allow

Service: servone_public_port (or whatever you named it above)

Source: Any

Destination: WAN IP Address

Users Allowed: All

Schedule: Always on

Logging: checked

Comment: (enter a short description)

And:

Action: Allow

Service: servtwo_public_port (or whatever you named it above)

Source: Any

Destination: WAN IP Address

Users Allowed: All

Schedule: Always on

Logging: checked

Comment: (enter a short description)

When you’re finished, attempt to access the webservers via the SonicWALL’s WAN IP address 
using a system located on the public Internet on the new custom port (example: http://
67.115.118.70:9100 and http://67.115.118.70:9200). You should be able to successfully 
connect. If not, review this section, and the section before, and ensure that you have entered 
in all required settings correctly.

This section contains the following subsections:

 shows the topology for the NAT load balancing network.