SonicWALL E6500 Manuale Utente
Page 40
Configuring L2 Bridge Mode
Configuring the Secondary Bridge Interface
Complete the following steps to configure the SonicWALL
appliance:
1.
appliance:
1.
Navigate to the Network > Interfaces page from the
navigation panel.
2.
Click the Configure icon in the right column of the X0 (LAN)
interface.
3.
In the IP Assignment drop-down, select Layer 2 Bridged
Mode.
4.
In the Bridged to drop-down, select the X1 interface.
5.
Configure management options (HTTP, HTTPS, Ping,
SNMP, SSH, User logins, or HTTP redirects).
Note:
Do not enable Never route traffic on the bridge-pair
unless your network topology requires that all packets
entering the L2 Bridge remain on the L2 Bridge
segments.
entering the L2 Bridge remain on the L2 Bridge
segments.
You may optionally enable the Block all non-IPv4
traffic setting to prevent the L2 bridge from passing
non-IPv4 traffic.
traffic setting to prevent the L2 bridge from passing
non-IPv4 traffic.
If You Are Following
Scenario...
Scenario...
Proceed to Section:
C - L2 Bridge Mode
NSA_E6500_GSG.book Page 40 Wednesday, June 17, 2009 7:16 PM