SMART Technologies 600i5 Manuale Utente
These commands control the appearance of your source. These settings are unavailable when the
projector is in Standby mode or when the source is disconnected. See Value-based command
methods on page 71 for setting absolute and adjustment commands.
Command
Command target range
Response
set displaymode [target]
=SMARTpresentation
=brightroom
=darkroom
=sRGB
=User
displaymode=[target]
set brightness [value]
=0 to =100
brightness=[value]
set contrast [value]
=0 to =100
contrast=[value]
set whitepeaking [value]
=0 to =10
whitepeaking=[value]
set degamma [value]
=0 to =3
degamma=[value]
set red [value]
=0 to =100
red=[value]
set green [value]
=0 to =100
green=[value]
set blue [value]
=0 to =100
blue=[value]
set cyan [value]
=0 to =100
cyan=[value]
set magenta [value]
=0 to =100
magenta=[value]
set yellow [value]
=0 to =100
yellow=[value]
set videofreeze [target]
=on
=off
videofreeze=[target]
set cc [target]
=cc1
=cc2
=off
cc=[target]
N
N O T E
Typically, cc1 displays English (U.S.) subtitles, while cc2 displays other regional languages, such
as French or Spanish, depending on television channel or media setup.
Additional VGA source controls
Your VGA source supports all the general source controls described in General source controls on
previous page, as well as the commands listed in this section. These settings are unavailable when
the projector is in Standby mode or when the VGA sources are disconnected.
N
N O T E
Some of these commands are invalid with HDMI input and Composite video sources, and will
return the response “invalidcmd=[command]”.
A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
74