Siemens TC63 Manuale Utente
TC63 AT Command Set
19.6 AT^SSYNC
s
TC63_ATC_V00.490
Page 449 of 501
5/24/05
Confidential / Draft - Do not copy
Note: When the ME is in Limited Service or IDLE mode with/without PDP context activated, the on/off time ratio
of the LED is always the same, no matter whether or not power saving is enabled. The only difference is that in
SLEEP mode the duration of the on/off periods is a multiple n of the equivalent periods without SLEEP mode.
The multiple n is synchronous to the active state of CTS during SLEEP mode (where CTS is set/reset every 0.9
- 2.7 seconds. See also
for the timing of CTS.
n * 75 ms on / n * 3 ms off Not possible: With
=1, LED
signalization is disabled in SLEEP
mode.
SLEEP mode is activated (
≠ 1) while the ME is
registered to the GSM network.
n * 500 ms on / n * 25 ms
off
Not possible: With
=1, LED
signalization is disabled in SLEEP
mode.
SLEEP mode is activated (
≠ 1) while the ME is
registered to the GSM network. Addi-
tionally, PDP context is activated.
LED behavior
ME operating status if
AT^SSYNC
=1
ME operating status if
AT^SSYNC
=2