Ridgid RD80763 Manuale Di Servizio

10

Fig. 6

See Figures 3 and 4.
  Locate the support feet, nuts, and bolts.
  Lift  the  machine  and  slide  the  support  feet  into  the  

machine base.

  Secure in place using the bolts and nuts.
  Locate the axle, hitch pins, washer, and wheels. Remove 

the hitch pin from the axle.

  Slide  the  axle  through  the  hole  in  the  center  of  the 

wheel. 

  Slide the washer onto the axle.
  Lift the machine and slide the axle into the wheel mount-

ing hole in the machine base as shown.

  Push the hitch pin into the hole on the end of the axle to 

secure the wheel assembly.

 

NOTE: The hitch pin should be pushed into the axle until 
the center of the pin rests on top of the axle.

  Repeat with the second wheel.

See Figure 5.
  Locate the trigger handle rest (front and back), screws, 

flat washer, and lock nut.

  Push the screws into the holes. Tighten securely using 

the lock nut.

See Figure 6.
  To raise the handle: pull the handle up until the handle 

knob snaps through the locking hole to secure the handle 
in place.

  To lower the handle: pull the handle knob out then lower 

the handle to the position shown in figure 6.

Failure to remove pump oil plug label may result in  
decreased pump life.

See Figure 6.
Remove pump oil cap label from the oil pump.

Fig. 5

Fig. 4