Ricoh IS300e Manuale Utente

Troubleshooting

179

This machine does not work in ac-
cordance with the scan settings 
configured on the Web Status 
Monitor.

• After configuring the scan settings (specifically, after 

clicking [OK] on the [Scan Settings] screen) on the Web 
Status Monitor, press the 

{{{{Clear Modes}}}} key. By press-

ing the 

{{{{Clear Modes}}}} key, the settings under [Scan Set-

 of this machine instantly reflect the settings 

configured using the Web Status Monitor.

Some of the registered destina-
tions are not displayed on the des-
tination list.

• Check if [All] is displayed at the top right corner of the 

“ Select destination(s). ” screen.

If another title like [A], [B] or [Freq.] is on the screen, it 
means that you have searched destinations using the 

{{{{./*}}}} (Title) key, and only the matched destinations are 
currently available for selection. In this case, press the 

{{{{./*}}}} (Title) key, highlight [All], and then press [OK]. See 
p.129 “To recall all available destinations” for details. 

The e-mail destinations (including 
Cc destinations) are cleared when 
a file name is specified.

When you perform a Send Scan operation, note the follow-
ing things.

• You cannot use the following functions at the same 

time:

• Scan to E-mail (referred to as “e-mail function” 

here)

• Scan to Folder (SMB) (referred to as “SMB function” 

here)

• Scan to FTP (referred to as “FTP function” here)

When you select [File Name] and then press [Settings] on 
the screen shown above, it means that you select either 
of the SMB or FTP function, and the e-mail function is 
disabled. Because of this, the e-mail destinations are 
cleared automatically.lSpecifying [To:], [Cc&co-
lon;]

, or [Subject] disables the SMB or FTP function. 

Specifying [SMB] disables the e-mail and FTP function. 
Specifying [FTP] disables the e-mail and SMB function.