RGB Spectrum Digital Recording and Streaming System DGy 201x Manuale Utente

. . . . .

IPADDRess

[ddd.ddd.ddd.ddd]

Without an argument, this command reports the 
DGy current IP address. 

To change the DGy IP address, enter the command 
followed by an argument.

: To set the IP address to 192.168.35.101, 

type 

IPADDR 192.168.35.101

 and press Enter

Use the 

 command to reboot the unit 

to activate the new IP address. 

Default 192.168.1.200

IPSubNET

[ddd.ddd.ddd.ddd]

Without an argument, this command reports the 
DGy current IP subnet mask. 

To change the IP subnet enter the command 
followed by argument.

: To set the IP subnet mask to 

255.255.255.1, type 

IPSNET 255.255.255.1

 and press Enter

Use the 

 command to reboot the unit 

to activate the new IP subnet mask. 

Default: 255.255.255.000

IPGateWay

[ddd.ddd.ddd.ddd]

Without an argument, this command reports the 
DGy current IP gateway address.

To change the gateway address, enter the 
command followed by an argument.

: To set the gateway address to 

192.168.35.1, type

IPGW 192.168.35.1

 and press Enter

Use the 

 command to reboot the unit 

to activate the new IP gateway.

MACADDRess

(none)

Reports the physical Ethernet (Media Access 
Controller) address.

RestoreFactoryDefaults

(none)

Restores all user settings to their factory default 
values. 

SYStemReSet

(none)

Causes the DGy to reboot. This command allows 
the system firmware to be restarted without having 
to use the front panel power switch.

(none)

Remotely shuts down the DGy.

: Do not remove the power cord from 

the DGy until one to two minutes after issuing the 
command. During shutdown, the power indicator on 
the front panel will remain on, but the DGy is 
inoperable. Failure to wait for the normal shutdown 
procedure to execute may cause loss of data.