Psion Teklogix 9160 G2 Manuale Utente
Psion Teklogix 9160 G2 Wireless Gateway User Manual
39
Chapter 4: Quick Steps For Setup And Launch
Connect The Access Point To Network And Power
For initial configuration with a direct Ethernet connection and no DHCP
server, be sure to set your PC to a static IP address in the same subnet as
the default IP address on the access point. (The default IP address for the
access point is 192.168.1.10.)
server, be sure to set your PC to a static IP address in the same subnet as
the default IP address on the access point. (The default IP address for the
access point is 192.168.1.10.)
If for initial configuration you use a direct Ethernet (wired) connection (via
crossover cable) between the access point and the computer, you will need
to reconfigure the cabling for subsequent startup and deployment of the
access point so that the access point is no longer connected directly to the
PC but instead is connected to the LAN (either via a Hub as shown in Fig-
ure 4.1, or directly).
crossover cable) between the access point and the computer, you will need
to reconfigure the cabling for subsequent startup and deployment of the
access point so that the access point is no longer connected directly to the
PC but instead is connected to the LAN (either via a Hub as shown in Fig-
ure 4.1, or directly).
Figure 4.1 Ethernet Connections Using DHCP
Administrator Computer
Access Point
HU
B
to
L
AN
AP
to
H
ub
Admin PC to Hub
LAN
HUB
ETHERNET CONNECTIONS WHEN USING DHCP FOR INITIAL CONFIGURATION