Proxima ASA PL-300 Manuale Utente

Configuring the Transmitter

22

ProjectionLink User & Installation Guide

One of the key features of the ProjectionLink system is that it 
allows you to use many different input devices with most Prox-
ima projectors. But before you begin using the system, you’ll 
need to set up the transmitter to match the projector you will 
be using. Again, we recommend you set up the transmitter 
and receiver with the appropriate cables prior to making your 
final installation. This will allow you to make any fine tuning 
adjustments more easily.

Use the tables in “Appendix C: Dip-Switch Settings” on page 
51 to set the dip-switches on the back of your transmitter. Dip-
switches one, two, three, four, and ten control the projector 
family. Dip-switches five through eight control the baud rate 
for the transmitter. Dip-switch nine controls the service mode 
for the transmitter. These settings will work for most applica-
tions

For typical applications, dip-switches five through 

eight should not be modified. For custom control 

applications, see “Appendix C: Dip-Switch Settings” 

Proxima Corporation
9440 Carroll Park Drive
San Diego, Ca 92121-2298
www.proxima.com
MN8, a trade mark of INT LABS, Inc.
Made in USA

POWER

9VAC, 1A

This device complies with Part 15 of the FCC Rules.  Operation is

subject to the following two conditions (1) this device may not cause

harmful interference, and (2) this device must accept any interference

received including interference that may cause undesired operation.

See user’s guide or Proxima

website for dipswitch settings

for your Proxima projector.

SERIAL NO.

Product Family

Baud Rate

ISP

Reserved

!

CAUTION

c

us