Plasmon V15 Manuale Utente

To Connect the library to the SCSI Bus:

1. Connect the host computer’s SCSI cable to one of the library’s SCSI connectors. The location 

of the library’s SCSI connectors is shown in the following figure.

 

When you attach the SCSI cables to the SCSI connectors, tighten the
SCSI cable jack screws to no more than 2.0 inch-pounds (2.3 kg-cm)
of torque.

2. Connect other SCSI cables, as necessary, depending on your bus configuration. If the library 

and tape drives are to share one bus, use jumper cables to connect them. For any device 
that terminates the bus, install a terminator on one of the SCSI connectors for that device.

For example, the illustration below shows how the library and tape drives can be connected 
to one SCSI bus.

 

 Library 

SCSI connectors

Tape drive 

SCSI connectors

Tape drive 

SCSI connectors

 Library 

SCSI connectors

 Terminator 

 Jumper cables 

SCSI cable 

(to host)