Pinnacle Speakers GBU070 Manuale Utente

GENERAL INSTRUCTIONS

1. Installation is allowed only by a licensed, bonded heating contractor.

2. Install this furnace in accordance with local mechanical codes and regulations.

3. Consult manual “J” of the air conditioning contractors Association (ACCA) or air 230

to estimate heating requirements.

4. Always install this furnace with adequate return and supply duct systems.

5. The installer must explain in detail, the operations of this furnace to owner/operator,

including minor service requirements.

6. Never block or restrict any air intake ports. Dangerous overheating can result.

7. Install this furnace with safe clearances to combustible surfaces.

8. Connect this furnace to its own independent Class L Chimney at least 4 inches in

diameter.

9. This is a good furnace, but it cannot make up for a poor or incorrect installation.

10. Repair should be done only by a qualified service person.

11. Never stack or pile combustible materials against the furnace.

12. Never use, store or dispose of flammable liquids near the furnace.

13. Always have a smoke or ionization detector installed in your home.

14. Disclaimer notice: No guarantee is made regarding the heating capacity of this

unit. The actual area that this unit will heat depends on factors such as conditions of
the building, heat loss, type of construction, the amount of insulation, type of air
movement, and the location of the furnace.

15. The manufacturer accepts no responsibility for improper installation of this

pellet/corn furnace or improper use or negligence of any kind with continued use of
the furnace.

16. The manufacturer recommends fuelling this furnace with premium wood based

pelletized fuel with moisture content between 2 – 8% or clean-shelled corn with a
moisture content less than 15%. Do not attempt to burn higher moisture content or
burn lesser grade fuels. Any questions regarding pellet fuel can be answered at the
Pellet Fuels Institute website, www.pelletheat.org.

17. If this furnace runs out of fuel, or misfires, it will automatically shut-off. If this

occurs, you must manually re-light the corn unit, repeating steps 8 – 14 in the start
up instructions on page 15. Re-light the pellet unit according to operating
instructions on page 14.

18. Do not operate this furnace with door open.