Phonetics 1104 Manuale Utente

• To enter “555,” press the number (5) key on the Touch-Tone

™

phone keypad three times. The Model 1104 will respond: *
“Warning message received by telephone number (last
number dialed).” The Model 1104 will hang up and the dial-
out sequence, including any further response to the alarm, will
be cancelled.

• If you enter the wrong code or do not enter it within 10

seconds following the conclusion of the message, the Model
1104 will respond: “Dial telephone number (the programmed
unit phone number) within (Intercall Time).” Then, the
Model 1104 will hang up. The alarm is still not acknowledged
until you call back. You have a period equal to the programmed
Intercall Time to call the unit back in order to acknowledge the
alarm. Refer to Callback Acknowledgment, Section 6.1.3,
below.

This method of remote alarm acknowledgment works with any
telephone: pulse, rotary, or Touch-Tone™.

Example: The Model 1104 calls you with an alarm message.  You
answer the call with a rotary or pulse telephone, and do the
following:

• You listen to the message and hang up.

• Then you call the Model 1104 back on any  telephone. You

must wait for 10 rings—this signals the Model 1104 to
answer your telephone call. (Make sure to call back within
the programmed setting for Intercall Time—refer to Chapter
4, Section 4.11.)

When the Model 1104 answers your return call, it gives a Status
Report (refer to Section 6.2). Then it says: “Warning message
received by ...” and recites the telephone number last dialed. This
indicates that the alarm has been acknowledged.

If you have the TAD feature ( telephone answering
device) enabled, the Model 1104 will answer the tele-
phone on the first ring. If it is disabled, the telephone
must be allowed to ring 10 times. This serves as a
precaution against a random alarm acknowledgment.
Refer to Chapter 4, Section 4.6, for complete infor-
mation on using the TAD feature.