Pelco PelcoNet Transmission System C1977M-D Manuale Utente

Pelco Manual C1977M-D (6/02)         

[ 65 ]

1. Connect a microphone (via a preamplifier) to the Line-In cinch plug or connect a handset to the RJ-11

plug on the unit.

2. Make sure the correct menu items are set in the Audio Configuration Page—that is, select the appro-

priate interface (line in/out or handset).

3. Switch the coding mode to G.711 or G.728.

4. Select a volume above zero.

5. Connect a loudspeaker to the PC’s soundcard. After establishing the Ethernet connection, audio

should be transmitted both ways.

6. Be sure not to set the level too low. Ensure the right interface is selected.

7. If you cannot hear any audio, check the microphone and loudspeaker together with other equipment.

Make sure the microphone is switched on if it has a power switch.

PelcoNet displays a warning message if there is a problem with the DX3000 DVR. Click this green button
to reset the unit. The codes are defined as follows:

None

Hard drive full

Hard drive near end

No signal

Copy or backup or restore—check media

Copy or backup or restore—size error

Archive full

Archive near end

Copy or backup—overtake error

Copy or backup—near overtake

Recording or copy or backup or restore or system—system error

Copy or backup or restore—read/write error