Trek TREK-725 Manuale Utente
35
Chapter 4
Option (F) Format Flash
Choose this option to format the flash. This will not overwrite EBOOT or
EBOOT parameters.
EBOOT parameters.
Option (L) Launch Existing Flash Resident Image Now
Choose this option to exit the menu, save any applicable changes that
were made and then launch the previously programmed flashed image.
were made and then launch the previously programmed flashed image.
Option (M) Display Mode Setup
Mode (0) (800x600), Mode (1) (640x480),
Mode (2) (1024x768), Mode (3) (320x24)
Mode (2) (1024x768), Mode (3) (320x24)
Choose this option to configure the display resolution. The default
TREK-725 configuration is Mode (0).
TREK-725 configuration is Mode (0).
Option (R) Reset to Factory Default Configuration
Choose this option to reset user-configurable settings to the following
factory defaults.
factory defaults.
Note: When you reset the user-configurable settings, you must change
option (C) Ethernet debugging setting from Enable to Disable for boot-
up Windows CE successfully.
option (C) Ethernet debugging setting from Enable to Disable for boot-
up Windows CE successfully.
IP address
192.168.80.2
Subnet mask
255.255.0.0
NPE0 MAC Address
80-86-22-22-22-22
NPE1 MAC Address
80-86-33-33-33-33
RNDIS MAC Address
80-86-44-44-44-44
Boot delay
5 seconds
DHCP
Enabled
Program RAM image into
FLASH
FLASH
Disabled
Check image signature(s)
Disabled
Automatic Startup Behavior
Download new image via Ethernet
Boot device order
PCI NIC RT8139D -> NPE0 -> NPE1
Ethernet debugging
Enabled