Texas Instruments Serial Programming Adapter MSP430 Manuale Utente
1
3
5
7
9
11
13
2
4
6
8
10
12
14
TDO/TDI
TDI/VPP
TMS
TCK
GND
TEST/VPP
JTAG
VCC TOOL
VCC TARGET
J1 (see Note A)
J2 (see Note A)
V
CC
R1
47 k
(see Note B)
W
C2
10 µF
C3
0.1 µF
0.1 µF
V /AV /DV
CC
CC
CC
RST/NMI
TDO/TDI
TDI/VPP
TMS
TCK
TEST/VPP (see Note C)
V /AV /DV
SS
SS
SS
MSP430Fxxx
C1
10 nF/2.2 nF
(see Notes B and E)
RST (see Note D)
www.ti.com
Signal Connections for In-System Programming and Debugging
A
Make either connection J1 in case a local target power supply is used or connection J2 to power target from the
debug/programming adapter.
debug/programming adapter.
B
The RST/NMI pin R1/C1 configuration is device family dependent. See the respective MSP430 family user's guide for
the recommended configuration.
the recommended configuration.
C
The TEST pin is available only on MSP430 family members with multiplexed JTAG pins. See the device-specific data
sheet to determine if this pin is available.
sheet to determine if this pin is available.
D
The connection to the JTAG connector RST pin is optional when using 4-wire JTAG communication mode
capable-only devices and not required for device programming or debugging. However, this connection is required
when using 2-wire JTAG communication mode capable devices in 4-wire JTAG mode.
capable-only devices and not required for device programming or debugging. However, this connection is required
when using 2-wire JTAG communication mode capable devices in 4-wire JTAG mode.
E
When using 2-wire JTAG communication capable devices in 4-wire JTAG mode, the upper limit for C1 should not
exceed 2.2 nF. This applies to both TI FET interface modules (LPT/USB FET).
exceed 2.2 nF. This applies to both TI FET interface modules (LPT/USB FET).
Figure 2-1. Signal Connections for 4-Wire JTAG Communication
25
SLAU278F – May 2009 – Revised December 2010
Design Considerations for In-Circuit Programming
© 2009–2010, Texas Instruments Incorporated