Telit Wireless Solutions GE863 Manuale Utente
GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
For example:
1- Let's assume you want to send a SMS that was written to the storage index position number 3. We
suppose you already have set up the device for text SMS mode as described on the previous
paragraphs:
command:
AT+CMSS=3
response:
+CMSS: 1
OK
In this case, the SMS was successfully sent to the destination and its network message reference
number is 1.
1- Let's assume you want to send a SMS that was written to the storage index position number 3. We
suppose you already have set up the device for text SMS mode as described on the previous
paragraphs:
command:
AT+CMSS=3
response:
+CMSS: 1
OK
In this case, the SMS was successfully sent to the destination and its network message reference
number is 1.
3.5.5 Sending a new SMS without storing it
A new SMS can be sent directly to the network without storing it.
•
send command
AT+CMGS="<da>"<cr>
where:
<da>: destination address
wait for prompt "
>
"
•
•
•
•
•
send SMS text (MAX 160 characters)
end command with CTRL-Z character (0x1A hexadecimal) or abort command with ESC character
(0x1B hexadecimal)
end command with CTRL-Z character (0x1A hexadecimal) or abort command with ESC character
(0x1B hexadecimal)
• wait for response:
Response
Reason
Action
+CMGS: <mr>
OK
OK
Message has been successfully
sent. <mr> represents the
message reference number.
sent. <mr> represents the
message reference number.
proceed ahead
ERROR
some error occurred
Enable the extended error
codes report (see par.2.5.2.1)
and retry.
codes report (see par.2.5.2.1)
and retry.
+CMS ERROR: 330
SMSC address unknown
Insert SMSC address (see par.
3.5.1.3)
3.5.1.3)
+CMS ERROR: 41
"Temporary Failure", may be
that the device is not registered
on any network
that the device is not registered
on any network
Check for signal strength and
network registration
network registration
+CMS ERROR: 331
No network service
Check for signal strength and
network registration
network registration
+CMS ERROR: 1
Unassigned number
The destination address
number does not exist. Check it
and repeat command.
number does not exist. Check it
and repeat command.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 68 of 109