Tapco MIX.FX MIX10FXP Manuale Utente

1.   Read these instructions.
2.   Keep these instructions.
3.   Heed all warnings.
4.   Follow all instructions.
5.   Do not use this apparatus near water.
6.   Clean only with a dry cloth.
7.   Do not block any ventilation openings. Install in accordance 

with the manufacturer’s instructions.

8.   Do not install near any heat sources such as radiators, heat 

registers, stoves, or other apparatus (including amplifi ers) that 

produce heat.

9.   Do not defeat the safety purpose of the polarized or 

grounding-type plug. A polarized plug has two blades with 

one wider than the other. A grounding-type plug has two 

blades and a third grounding prong. The wide blade or 

the third prong are provided for your safety. If the provided 

plug does not fi t into your outlet, consult an electrician for 

replacement of the obsolete outlet. 

10.  Protect the power cord from being walked on or pinched 

particularly at plugs, convenience receptacles, and the point 

where they exit from the apparatus. 

11.  Only use attachments/accessories specifi ed by the 

manufacturer.

12.  Use only with a cart, stand, tripod, bracket, or table specifi ed 

by the manufacturer, or sold with the apparatus. When a 

cart is used, use caution when moving the cart/apparatus 

combination to avoid injury from tip-over.

13.  Unplug this apparatus during lightning storms or when unused 

for long periods of time.

14.  Refer all servicing to qualifi ed service personnel. Servicing 

is required when the apparatus has been damaged in any 

way, such as when the power-supply cord or plug has been 

damaged, liquid has been spilled or objects have fallen into 

the apparatus, the apparatus has been exposed to rain or 

moisture, does not operate normally, or has been dropped.

15.  This apparatus shall not be exposed to dripping or splashing, 

and no object fi lled with liquids, such as vases, shall be 

placed on the apparatus.

16.  This apparatus has been designed with Class-I construction 

and must be connected to a mains socket outlet with a 

protective earthing connection (the third grounding prong).

17.  The MAINS plug or an appliance coupler is used as the 

disconnect device, so the disconnect device shall remain 

readily operable.

18.  This apparatus has been equipped with a double-pole AC 

mains power switch. This switch is located on the rear panel 

and should remain readily accessible to the user.

19.  NOTE: This equipment has been tested and found to comply 

with the limits for a Class B digital device, pursuant to part 

15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses, and 

can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference 

to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following 

measures:

• 

Reorient or relocate the receiving antenna.

• 

Increase the separation between the equipment and 

the receiver.

• 

Connect the equipment into an outlet on a circuit 

different from that to which the receiver is connected.

• 

Consult the dealer or an experienced radio/TV 

technician for help.

 

CAUTION: Changes or modifi cations to this device not 

expressly approved by LOUD Technologies Inc. could void the 

user's authority to operate the equipment under FCC rules.

20.  This apparatus does not exceed the Class A/Class B 

(whichever is applicable) limits for radio noise emissions 

from digital apparatus as set out in the radio interference 

regulations of the Canadian Department of Communications.

ATTENTION —Le présent appareil numérique n’émet pas de bruits 
radioélectriques dépassant las limites applicables aux appareils numériques 
de class A/de class B (selon le cas) prescrites dans le règlement sur le 
brouillage radioélectrique édicté par les ministere des communications du 
Canada.

21.  Exposure to extremely high noise levels may cause permanent 

hearing loss. Individuals vary considerably in susceptibility to 

noise-induced hearing loss, but nearly everyone will lose some 

hearing if exposed to suffi ciently intense noise for a period of 

time. The U.S. Government’s Occupational Safety and Health 

Administration (OSHA) has specifi ed the permissible noise level 

exposures shown in the following chart.

 

According to OSHA, any exposure in excess of these 

permissible limits could result in some hearing loss. To ensure 

against potentially dangerous exposure to high sound 

pressure levels, it is recommended that all persons exposed to 

equipment capable of producing high sound pressure levels 

use hearing protectors while the equipment is in operation. 

Ear plugs or protectors in the ear canals or over the ears must 

be worn when operating the equipment in order to prevent 

permanent hearing loss if exposure is in excess of the limits set 

forth here:

Duration Per Day   Sound Level dBA, 

Typical

  In Hours 

Slow Response 

Example

 

8 

90 

Packed garage concert

 6 

92 

 

 

4 

95 

VW Bus Peace Train

 3 

97

 

2 

100 

Cranked psychedelic tunes

    1.5 

102

 

1 

105 

High speed chase on C.H.I.P.s

 0.5 

 

110

   0.25 or less 

115 

Loudest parts at a Heavy Metal concert

Carts and stands - The
Component should be used
only with a cart or stand
that is recommended by
the manufacturer.
A Component and cart
combination should be
moved with care.  Quick
stops, excessive force, and
uneven surfaces may cause
the Component and cart
combination to overturn.

RISK OF ELECTRIC 

SHOCK 

DO NOT OPEN

RISQUE DE CHOC ELECTRIQUE

NE PAS OUVRIR

ATTENTION: POUR EVITER LES RISQUES DE CHOC

ELECTRIQUE, NE PAS ENLEVER LE COUVERCLE. AUCUN

ENTRETIEN DE PIECES INTERIEURES PAR L'USAGER. CONFIER

L'ENTRETIEN AU PERSONNEL QUALIFIE.

AVIS: POUR EVITER LES RISQUES D'INCENDIE OU

D'ELECTROCUTION, N'EXPOSEZ PAS CET ARTICLE 

A LA PLUIE OU A L'HUMIDITE

   The lightning flash with arrowhead symbol within an equilateral 

triangle is intended to alert the user to the presence of uninsulated

“dangerous voltage” within the product’s enclosure that may be 

of sufficient magnitude to constitute a risk of electric shock to persons.
   Le symbole éclair avec point de flèche à l'intérieur d'un triangle 

équilatéral est utilisé pour alerter l'utilisateur de la présence à 

l'intérieur du coffret de “voltage dangereux” non isolé d'ampleur 

suffisante pour constituer un risque d'éléctrocution.

   The exclamation point within an equilateral triangle is intended to 

alert the user of the presence of important operating and maintenance 

(servicing) instructions in the literature accompanying the appliance.
   Le point d'exclamation à l'intérieur d'un triangle équilatéral est 

employé pour alerter les utilisateurs de la présence d'instructions 

importantes pour le fonctionnement et l'entretien (service) dans le 

livret d'instruction accompagnant l'appareil.