Omron SYSMAC C200HW-ZW3AT2-E-V2 Manuale Utente
!
4-3
Section
Interconnecting Networks
40
3. Transferring the Routing Tables
Transfer the routing tables to nodes.
•
Main Item Selection
Main Menu
Main Menu
→
R:Routing table
→
Routing table submenu (F2)
→
T:Trans-
fer
→
W:Computer
→
PC/Board
4. Saving the Routing Tables
Routing tables can be edited for only one node at a time. Therefore, always
save the routing tables as a file after transferring them to the node.
save the routing tables as a file after transferring them to the node.
Repeat the routing table creation/check/transfer/save procedures until the
routing tables are registered at all nodes.
routing tables are registered at all nodes.
•
Main Item Selection
Main Menu
Main Menu
→
R:Routing table
→
Routing table submenu (F2)
→
S:Save
Caution
Once routing tables are transferred to a PC, all CPU Bus Units at the node will be
reset. This is for the purpose of reading and enabling the set routing tables.
Before transferring the routing tables, always make sure that the equipment will
not be affected.
reset. This is for the purpose of reading and enabling the set routing tables.
Before transferring the routing tables, always make sure that the equipment will
not be affected.