Quantum Audio DAT72 Manuale Utente

Installing internal tape drives

Collecting the Necessary Tools

Access the Inside of the Computer
See “Accessing the Inside of Your Computer” on page 26.

Collecting the Necessary Tools

Before proceeding with the installation, gather the tools you will need to install the internal tape 
drive into the computer mounting bay. The following list identifies some of the tools you will need. 
You may need additional items, depending on your installation requirements.

Phillips screwdriver

Flatblade screwdriver, if your computer uses flathead screws

Torx screwdriver, if your computer uses torx screws

Computer documentation, which you can refer to during the installation

Reviewing Drive Default Settings

Your internal tape drive comes with various default settings. These settings are configured using 
jumpers and switches.

The jumpers are located on the back of the drive, between the SCSI interface and power con-
nectors (see Figure 3 on page 20)

The switches are located on the underside of the drive. If you change a switch setting, you 
must turn the drive off and then on to have the new setting take effect (see Figure 4 on 
page 21).

You may need to change these settings to suit your requirements. Review the default settings in 
Table 2 on page 20 to determine whether they suit your requirements or need to be changed. 

If you do not need to change these default settings, skip to “Accessing the Inside of Your Com-
puter” on page 26.

To change one or more settings, refer to the appropriate page in Table 2 on page 20.