Novell ZENworks Endpoint Security Management 3.5 Manuale Utente

ZENworks® ESM 3.5

Administrator’s Manual

202

The Stamp Once script enforces a single network environment save at a designated location. 
When the user enters the desired network environment, they should be instructed to switch to the 
location assigned below and then perform a network environment save (see the ZSC User’s 
Manual or Help). After this environment has been saved, the ZSC will not permit additional 
network environments to be saved at that location.

This script works best when used for an environment that will likely NOT change its network parameters 
(i.e., an end-user’s home network, or a satellite office). If network identifiers change (IP and/or MAC 
addresses) the ZSC may not be able to recognize the location, and will remain in the default Unknown 
location.

To initiate the Stamp Once Script, perform the following steps:

Step 1: Under Locations, create or select the location which will use the Stamp Once functionality 

Step 2: IMPORTANT: under User Permissions, un-check Save Network Environment 

Step 3: Associate the Stamp Once scripting rule to this policy 

Step 4: Set the triggering event to Location Change: Activate when switching to. Select the 

configured location from Step 1 and 2 above 

Step 5: Open the location_locked variable and select the same location as in step 4, above