NEC 2400 PX Manuale Utente
NEAX2400 IPX Feature Programming Manual
Page 708
NDA-24297, Issue 1
S-33
Software Line Appearance
S-33 Software
Line
Appearance
General Description
This feature permits ports that do not physically exist to be used as sub-lines on D
term
stations. Ports normally
reserved on a D
term
for data stations only, can be assigned as a SOFTWARE LINE APPEARANCE. Additionally,
64 software ports have been added to a Port Interface Module. The 64 software-assigned ports can be assigned as
virtual line appearances on D
virtual line appearances on D
term
stations. The use of the data ports and the 64 software-assigned ports conserve
valuable hardware for stations and trunks.
Operating Procedure
Call Origination via a SOFTWARE LINE APPEARANCE on a D
term
1.
Press the Software Line Appearance key, then either press the SPEAKER key or lift the handset.
2.
Upon hearing dial tone, dial the desired number.
Calling a SOFTWARE LINE APPEARANCE from a station/trunk/Attendant Console
1.
The calling party dials the telephone number of the SOFTWARE LINE APPEARANCE.
2.
Any D
term
accommodating the SOFTWARE LINE APPEARANCE will receive ringing and have an
incoming lamp display. The D
term
user presses the LINE key and goes off-hook to answer the incoming
call.
Service Conditions
1.
When using a SOFTWARE LINE APPEARANCE assigned to a data port (TEC:12), call origination from
that line appearance can be made if the card is mounted in that slot.
that line appearance can be made if the card is mounted in that slot.
2.
A mix of data ports and sub-lines can be assigned on a D
term
package.
3.
All sub-lines of D
term
s must be located in the same Local Processor as the MY-Line of that D
term
.
4.
A SOFTWARE LINE APPEARANCE cannot be assigned as a Hotline Station, but can be assigned as a
BROKERAGE HOTLINE [B-12] station.
BROKERAGE HOTLINE [B-12] station.
5.
A SOFTWARE LINE APPEARANCE cannot activate:
CALL BACK
[C-1]
OUTGOING TRUNK QUEUING
[O-2]
NAILED-DOWN CONNECTION
[N-9]
6.
When activating CALL PICKUP-GROUP [C-7], the sub-line will pick up calls assigned to the CALL
PICKUP-GROUP of the MY-Line of the D
PICKUP-GROUP of the MY-Line of the D
term
on which the sub-line appears.
7.
When accessing or entering SPEED CALLING [S-2] group/station data, a SOFTWARE LINE
APPEARANCE will enter or access the SPEED CALLING [S-2] group/station data of the MY-Line of
the D
APPEARANCE will enter or access the SPEED CALLING [S-2] group/station data of the MY-Line of
the D
term
on which the sub-line appears.
8.
The STATION MESSAGE DETAIL RECORDING (SMDR) [S-10] of the SOFTWARE LINE
APPEARANCE call activity will be recorded as the MY-Line call activity.
APPEARANCE call activity will be recorded as the MY-Line call activity.
9.
The SOFTWARE LINE APPEARANCE cannot be the called station of the following features:
VOICE CALL
[V-2D]
MESSAGE REMINDER
[M-22D]
BOSS-SECRETARY OVERRIDE
[B-5]
10.
Station PEG COUNT [P-7] data will be recorded for SOFTWARE LINE APPEARANCEs as a MY-Line
of the D
of the D
term
.
11.
If the DO NOT DISTURB - D
term
[D-11D] key is activated by the SOFTWARE LINE APPEARANCE,
ringing will not be sent to the port of the MY-Line of the D
term
.