NEC 2400 PX Manuale Utente
NEAX2400 IPX Feature Programming Manual
Page 848
NDA-24297, Issue 1
C-48
Call Forwarding - Intercept - CCIS
Programming (cont’d)
STEP 3:
MBTK
- Assign the Make Idle status to the Announcement Trunk.
Note:
If supervision is required, use the first two circuits of the COT card. Move the switch on the COT card to
PGT.
PGT.
STEP 4:
ARRC
- If TIE Line or REMOTE ACCESS TO PBX [R-2] connection to the Announcement Service
Trunk is required, allow trunk-to-trunk connection using ARI-D-RES, Direct Connection.
STEP 5:
AAED
- Used to assign Announcement equipment.
DEAD LEVEL
Assign:
TN:
Assign:
TN:
Tenant Number;
EQP:
(Announcement Equipment Number) = 0 (Dead Level). Example: If level 6 is not assigned,
an announcement is heard instead of reorder tone.
an announcement is heard instead of reorder tone.
RT, TK: Route & Trunk number of the trunk connected to the announcement equipment:
C:
Duration of Connection, 0/1: Disconnection occurs in 30 seconds / the connection is held
until the station releases. See the requirements of the announcement equipment.
until the station releases. See the requirements of the announcement equipment.
R:
Sending RBT, 0/1: Sending RBT/Not sending RBT. Normally assign data “0”.
A:
Answer Signal Sending, 0/1: No answer from Incoming trunk/Answer from Incoming trunk.
Normally assign data “0”. No answer signal is sent to the CO. Therefore calling party will
not be billed for the call.
Normally assign data “0”. No answer signal is sent to the CO. Therefore calling party will
not be billed for the call.
M:
Multiple Connection 0/1: Single Connection/Multiple Connection. See the requirements of
the announcement equipment.
the announcement equipment.
UNUSED NUMBER
Assign:
TN:
TN:
Tenant Number;
EQP:
(Announcement Equipment Number) = 1 (Unused Number).
Example: If ext.-7836 is not in the system, the announcement is heard instead of reorder
tone.
tone.
RT, TK: Route & Trunk number of the trunk connected to the announcement equipment:
C:
Duration of Connection, 0/1: Disconnection occurs in 30 seconds/the connection is held
until the station releases. See the requirements of the announcement equipment.
until the station releases. See the requirements of the announcement equipment.
R:
Sending RBT, 0/1: Sending RBT/Not sending RBT. Normally assign data “0”.
A:
Answer Signal Sending, 0/1: No answer from Incoming trunk/Answer from Incoming trunk.
Normally assign data “0”. No answer signal is sent to the CO. Therefore calling party will
not be billed for the call.
Normally assign data “0”. No answer signal is sent to the CO. Therefore calling party will
not be billed for the call.
M:
Multiple Connection 0/1: Single Connection/Multiple Connection. See the requirements of
the announcement equipment.
the announcement equipment.
STEP 6:
ACFR
- Assignment of Call Forwarding Restriction. Upon determining which types of Call Class
Indexes (CCI) will be answered via CALL FORWARDING-INTERCEPT - CCIS (i.e., CCSA and
DID calls), allow those CCIs a Transfer Service Feature Index of 1, Call Forward-All Calls, Don’t
Answer, Busy.
DID calls), allow those CCIs a Transfer Service Feature Index of 1, Call Forward-All Calls, Don’t
Answer, Busy.
COT Card
CKT 0
CKT 1
Ring, not used
Voice Tip
Voice
Supervisory Ground