NEC 2400 PX Manuale Utente
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
NDA-24297, Issue 1
Page 921
Hotline - CCIS
H-12
H-12
Hotline - CCIS
General Description
This feature allows two stations at different nodes in the CCIS network to be associated with one another on an
automatic ringdown basis.
automatic ringdown basis.
Operating Procedure
1.
Station A lifts the handset.
2.
Station B is rung.
3.
Station B lifts the handset; the connection is established.
Service Conditions
1.
If both phones in a HOTLINE - CCIS pair are equipped with dials, either one may transfer a HOTLINE -
CCIS call to another station in the CCIS network, using the CALL TRANSFER-ALL CALLS - CCIS [C-
50] feature.
CCIS call to another station in the CCIS network, using the CALL TRANSFER-ALL CALLS - CCIS [C-
50] feature.
2.
There is no limit to the number of originating HOTLINE - CCIS stations.
3.
HOTLINE - CCIS assignments are programmed into system data via the Maintenance Administration
Terminal (MAT).
Terminal (MAT).
4.
HOTLINE - CCIS uses SPEED CALLING-SYSTEM [S-3] memory. Therefore, a total of 1000
HOTLINE - CCIS destinations, HOTLINE-OUTSIDE [H-9], and SPEED CALLING-SYSTEM codes are
available.
HOTLINE - CCIS destinations, HOTLINE-OUTSIDE [H-9], and SPEED CALLING-SYSTEM codes are
available.
5.
OUTGOING TRUNK QUEUING - CCIS [O-12] is not provided for a HOTLINE - CCIS call.
6.
A HOTLINE - CCIS station can be assigned as a line/feature key on a D
term
. See TRUNK LINE
APPEARANCE
7.
The MY-Line of a D
term
cannot be assigned as a HOTLINE - CCIS.
Interactions
1.
The connecting station does not have to be a HOTLINE station. If the connecting station is busy, the
HOTLINE station will hear reorder tone, or CALL WAITING-ORIGINATING [C-31] will be
automatically set.
HOTLINE station will hear reorder tone, or CALL WAITING-ORIGINATING [C-31] will be
automatically set.
2.
CALL BACK [C-1]: If the connecting station of a HOTLINE connection is busy, CALL BACK is
allowed.
allowed.
3.
CONSULTATION HOLD-ALL CALLS [C-58]: The HOTLINE station may put the destination station
on CONSULTATION HOLD-ALL CALLS. In this state, the HOTLINE station may make an outgoing
call and is therefore affected by CLASS OF SERVICE-INDIVIDUAL [C-15].
on CONSULTATION HOLD-ALL CALLS. In this state, the HOTLINE station may make an outgoing
call and is therefore affected by CLASS OF SERVICE-INDIVIDUAL [C-15].
4.
CALL WAITING-ORIGINATING [C-31]: A HOTLINE is allowed to camp-on to a busy destination
station. Assign SFI 5 (Call Waiting-Calling Side), SFI 6 (Call Waiting-Called Side) to SFC 0 and CDN
46:CW at the remote node.
station. Assign SFI 5 (Call Waiting-Calling Side), SFI 6 (Call Waiting-Called Side) to SFC 0 and CDN
46:CW at the remote node.
5.
If the connecting station is also a HOTLINE, then the reverse connection must also be programmed.