NEC MDG5-BNDN1 Manuale Utente

English

LCD panel color

Clear Base

LCD

21.3-inch (54 cm), monochrome, TFT active matrix, anti-glare

Pixel pitch (H x V)

0.165 x 0.165 mm

Display area (H x V)

337.9 x 422.4 mm

Pixel (H x V)

2048 x 2560

Grayscale

256 steps of gray out of a palette of 12277

Backlight

Edge Light Type with white LED

LCD Optical characteristics (typ.)

Viewing angle: 176° horizontal/vertical (contrast ratio 

≥ 50:1)

Contrast ratio: 1200:1 (Viewing angle perpendicular to LCD panel)

Luminance

DICOM calibrated 

500 cd/m

2

 as factory default

Maximum 600 

cd/m

2

 (1200 cd/m

2

 typ. as LCD component)

Input sync signal

DVI 1.0 compliant, DisplayPort 1.2 compliant

Available resolution

640 x 480
800 x 600
1024 x 768
2048 x 2560 (at Fv=25/50Hz)
2560 x 2048 (at Fv=25/50Hz)

Input connectors

DVI 24-pin connector, DisplayPort connector

Power Supply

AC 100-240 V ~ 50/60 Hz

Current Rating

1.5 - 0.6 A

USB Hub

USB Rev. 2.0 compliant, Self-powered
USB upstream port (x1), USB downstream ports (x2)

Ambient conditions 

Temperature:

 

Humidity (no condensation):

  

Air pressure:

Operating: 5 - 35°C, Transport / Storage: -20 - 60°C
Operating: 20 - 80%, Transport / Storage: 10 - 85%
Operating: 700 - 1060hPa, Transport / Storage: 266 - 1060hPa

Dimensions & weight  

Net:

(W x H x D) 

Packed:

390 x 487.8/584 x 227.6 mm (W x H x D: Portrait) approx. 11.8 kg
475 x 705 x 345 mm (W x H x D). approx. 15.8 kg

Safety certifi cations

ANSI/AAMI ES60601-1:2005, CAN/CSA-C22.2 No. 60601-1:08, FCC-B, CE-MDD, VCCI-B

Technical specifi cations are subject to change without notice.

• 

Make sure the display is plugged.

• 

Check to see if the display is turned on.

• 

Check if cables are connected correctly.

• 

Check if the computer is turned on.

• 

If the LED indicator is orange, the computer may be in power saving mode. Press any key on the keyboard to wake up 
the computer.

• 

The input signal frequency or display resolution may not be appropriate for the display. Refer to the computer instruction 
manual and adjust the frequency and/or resolution.

• 

If the LED is red, this may be an error indication. Contact your supplier.

• 

The display resolution may not be appropriate for the display. Refer to the computer instruction manual and adjust 
resolution.

• 

This can happen when a single-link cable or a DisplayPort to Single Link adapter is used. Use the supplied dual-link 
cable which supports both single-link (25Hz) and dual-link (50Hz) modes, or set the refresh rate to 25Hz.