NEC EXPRESS 5800 Manuale Utente
3-42 Configuring Your System
The following describe the clearing procedure.
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See 'Using
This Guide" for details.
these instructions may result in death or serious personal injury. See 'Using
This Guide" for details.
!
Do not disassemble, repair, or alter the server.
!
Do not remove the lithium battery.
!
Do not connect the ground line to a gas pipe.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See 'Using
This Guide" for details.
these instructions may result in death or serious personal injury. See 'Using
This Guide" for details.
!
Do not lift the server only by a single person.
!
Make sure to complete board installation.
!
Do not install the server on a rack with leaving covers removed.
!
Do not pinch your finger with mechanical components.
!
Note high temperature.
!
Do not pull out a device from the rack if the rack is unstable.
!
Do not leave more than one device being pulled out from the rack.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Open the top cover.
4.
Change the setting of the jumper switch of the target function to clear (PSWD or CMOS
Clear).
Clear).
IMPORTANT:
Be careful not to lose the clip.
5.
Assemble the server as it was, and press the POWER switch.
The following messages are displayed at completion of POST:
The following messages are displayed at completion of POST:
ERROR:
0120: NVRAM cleared By jumper
0120: NVRAM cleared By jumper
Press <F1> to Resume, Press <F2> to run SETUP.