NEC EXPRESS 5800 Manuale Utente

The following sections describe the necessary preparation procedures for installing
SCO OpenServer 5.0.6.

DOS Partitions: MS-DOS allows installation of multiple primary
DOS partitions. However, SCO Open Systems Software allows
only one primary DOS partition and one extended DOS partition
on the boot drive. If you install more than one primary and one
extended DOS partition, SCO Open Systems Software will be
unable to access any DOS partition.

Before installing SCO, make sure that your system configuration is correct. Run the
BIOS Setup Utility to check system configuration. Refer to the Configuring Your
System chapter of your User's Guide for more information on how to run these
utilities.

1

File Server Name. Record the file server name for this system.

File server name: _________________________

2

IP Address. Assign an IP address for each LAN card that is to be installed into the
system. Seven maximum.

IP Address Number: _______________________

IP Address Number: _______________________

IP Address Number: _______________________

IP Address Number: _______________________

IP Address Number: _______________________

3

License Number. Record the license number for the SCO OpenServer operating
system.

License number: _________________________

4

License Code. Record the license code for the SCO OpenServer operating system.

License code: _________________________