NEC EXPRESS 5800 Manuale Utente

If you are using Windows NT 4.0, follow the procedure below to recover the system.

System Recovery

Follow the procedure below and use the information in the disk, not system recovery disk, to
recover the system.

Turn on the power of the system.

Insert Windows NT 4.0 CD- ROM into the CD-ROM drive of your server.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot the server.  (You may
also turn off and then on again to reboot the server.)

After turning the system power on, press F6 at either of the following situation:

!

 

The message "Setup is inspecting your computer's hardware configuration..." is being
displayed.

!

 

The whole blue screen is being displayed.

The message "Setup could not detect more than one mass storage driver which is
installed in the system." and the input requesting screen will appear.

If the input requesting screen does not appear, F6 is not pressed correctly.  Press F3 to
exit the setup and turn on the system power once again to start the setup.

Press S.

Select [Others] and press Enter.

Insert Windows NT 4.0 OEM-DISK for EXPRESSBUILDER #1 into the floppy disk
drive and press Enter.

Select [Adaptec Ultra 160/m Family PCI SCSI Controller] and press Enter.
The screen will go back to step 5.

If the disk array controllers are mounted on the device, repeat the steps 5 to 7 and select
[Mylex AcceleRAID 160/352 Disk Array Controller].
Follow the message displayed on the screen until [Welcome to Setup] screen appears.

Press R to select recovery option.

Select the task to execute and continue the procedure.

Follow the message and press Enter on the screen which request you to insert system
recovery disk.
The message "Windows NT is detected in the following directory on your hard disk."
will appear.