NEC EXPRESS 5800 Manuale Utente

Install the components you removed in steps 1 to 3.

Power on the server and verify that POST displays no error messages.

If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 6.

Start the SETUP and select [Advanced] 

→

 [Memory Configuration] to verify that the

installed DIMM shows the status "Installed". (See Chapter 3 or details.)

Select "Yes" for [Reset Config Data] on the [Advanced] menu.

This setting is required to change the hardware configuration data. See Chapter 3 for
details.

If Windows 2000 or Windows NT 4.0 is in use, set the paging file size to the
recommended value or a greater value as shown below.

–  For Windows 2000:

Total memory size × 1.5

–  For Windows NT 4.0: Total memory size + 12MB

If NetWare is in use, reserve the disk space in the MS-DOS partition for a memory dump.