NEC EXPRESS 5800 Manuale Utente
7-40 Upgrading Your System
!
SCSI cable connection
To use the internal hard disk drives in a disk array configuration, disconnect the SCSI
cable from the SCSI connector on the system board, and connect it to the connector of
the disk array controller board.
cable from the SCSI connector on the system board, and connect it to the connector of
the disk array controller board.
Full-height type
Standard SCSI cable (Do not run the
cable on the power supply unit.
Form the cable so that it runs under
the board.)
cable on the power supply unit.
Form the cable so that it runs under
the board.)
If using the Mylex AcceleRAID 352
disk array controller, connect it to
the connector on the rear of the
server.
disk array controller, connect it to
the connector on the rear of the
server.
Low-profile type
Standard SCSI cable
SCSI cable provided for a disk array
With the Mylex AcceleRAID 160
disk array controller installed on the
full-height riser card
disk array controller installed on the
full-height riser card