NEC EXPRESS 5800 Manuale Utente
1-42 System Overview
After removing the CD, retract the tray into the drive.
When you fail to eject the CD-ROM tray with the Eject button, follow the procedure below.
When you fail to eject the CD-ROM tray with the Eject button, follow the procedure below.
1.
Press the server POWER switch to power off the server. (The POWER/SLEEP lamp
goes off.)
goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a
straightened large paper clip will make a substitute) into the emergency hole on the right
front of the CD-ROM drive and gently push it in until the tray is ejected.
straightened large paper clip will make a substitute) into the emergency hole on the right
front of the CD-ROM drive and gently push it in until the tray is ejected.
IMPORTANT:
!
Do not use a toothpick or plastic stick that is easy to break.
!
If the above procedure does not allow you take out the CD-ROM,
contact your service representative.
contact your service representative.
3.
Hold the tray and pull it out.
4.
Take out the CD.
5.
Push the tray back into position.
Emergency hole