NEC EXPRESS 5800 Manuale Utente

This server can be installed in either the NEC rack or a vendor's rack.  The following procedure
describes hoe to install the server in the rack:

 When installing the cable arm, see the instruction manual

provide with the cable arm assembly.

Removing the Rail Assemblies

Remove the sliding rails from the server.

Hold the rails and slowly slide them toward the rear of the server until a "click" is heard.
The click indicates that the rails are locked.

Push the release levers on the right and left sides of the server, and remove the rail
assemblies from the server while unlocking.

Only the inner rails remain screwed to the server when the rail assemblies have been
removed.

 The removed rail assemblies will be installed on the inner

rails later.  To install each rail assembly on the correct inner rail, make a
mark on the assemblies.  Similarly, when installing more than one server,
distinguish between the pairs of inner rails and rail assemblies of the
servers by making marks.

Inner rail

Release lever