NEC NEAX2000 IVS2 Manuale Utente
NEAX2000
IVS
2
Q-SIG System Manual
Page 32
ND-70923 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
How to Read This Chapter
HOW TO READ THIS CHAPTER
In the programming procedure, the meaning of (1), (2) and markings are as follows.
(1)
:
1st Data
(2)
:
2nd Data
:
Initial Data
With the system data clear command (CM00, CM01), the data with this marking is
automatically assigned for each command.
With the system data clear command (CM00, CM01), the data with this marking is
automatically assigned for each command.
: System Initialization
After entering the data, system reset is required (Depress SW1 on the MP
card).
card).
: DCH Initialization
A reset of the DCH card is required after data setting.
Set the Make Busy switch to UP and then Down.
Set the Make Busy switch to UP and then Down.
INITIAL
DCH INITIAL