NEC NEAX2000 IVS2 Manuale Utente
NEAX2000
IVS
2
Q-SIG System Manual
Page 38
ND-70923 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
Tandem Connection Assignment
TANDEM CONNECTION ASSIGNMENT
To provide Tandem Connection (Tie Line to Q-SIG, Q-SIG to Tie Line), do the following
programming.
programming.
DESCRIPTION
DATA
Specify whether the busy tone is sent to a
calling party of Q-SIG when a called party
is busy in the tandem connection (Q-SIG
to COT).
calling party of Q-SIG when a called party
is busy in the tandem connection (Q-SIG
to COT).
(1)
(2)
(2)
407
0
0
: Available (BT)
1
: Not available (RBT)
Specify the combination of trunk routes
allowing the tandem connection.
allowing the tandem connection.
(1)
(2)
XX YY
XX : 00-63 (Incoming Trunk Route)
YY : 00-63 (Outgoing Trunk Route)
0
XX : 00-63 (Incoming Trunk Route)
YY : 00-63 (Outgoing Trunk Route)
0
: Allow
1
: Restricted
Specify the timing start when making a Q-
SIG call from a station (PB/DP telephone,
SIG call from a station (PB/DP telephone,
D
term
) or Attendant Console for the
tandem connection.
NOTE 1: By using this command, a
Q-SIG call is available even if
“#” is not dialed.
“#” is not dialed.
NOTE 2: This command is effective for
dialing a called number. When
dialing a called party
subaddress, this command is
not effective.
dialing a called party
subaddress, this command is
not effective.
•
(1)
(2)
(2)
Y=0
57
03-14: 3-14 sec. (1 sec. increments)
57
03-14: 3-14 sec. (1 sec. increments)
If no data is set, the timing start is not
effective.
effective.
CM41
START
END
CM08
CM36