National Instruments TV Video Accessories NI PXIe-8106 Manuale Utente

This document contains information about installing your NI PXIe-8106 
controller in a PXI Express chassis. For complete configuration and 
troubleshooting information (including information about BIOS setup, 
adding RAM, etc.), refer to the NI PXIe-8106 User Manual. The manual is 
in PDF format on the recovery CD included with your controller and on the 
National Instruments Web site, 

ni.com/manuals

.

This section contains general installation instructions for the 
NI PXIe-8106. Consult your PXI chassis user manual for specific 
instructions and warnings.

1.

Plug in your chassis before installing the NI PXIe-8106. The power 
cord grounds the chassis and protects it from electrical damage while 
you install the module. Make sure the chassis power is turned off.

In some National Instruments chassis, such as the NI PXIe-1062Q, 
ensure that the power LED is off. For more information about chassis 
power behavior, refer to the user manual for the specific chassis.

2.

Remove any panels blocking access to the system controller slot 
(Slot 1) in the chassis.

3.

Touch the metal part of the chassis case to discharge any static 
electricity that might be on your clothes or body.

4.

Remove the protective plastic covers from the four bracket-retaining 
screws as shown in Figure 1.

5.

Make sure the injector/ejector handle is in its downward position. 
Align the NI PXIe-8106 with the card guides on the top and bottom of 
the system controller slot.