Kettler 2533 Dépliant

 © 

Kettler USA 309.01

2533 ADIRONDACK BAR STOOL

(1) Seat, (1) Back

(2) Arm Rests

(2) Front Chair legs

(2) Back Chair legs

(1) Footrest

(2) Side Braces

7/16” Wrench

(1) Short Cross Brace

(4) Cross Braces

(22) 1/4 - 20 x 2” Bolts

(6) 1/4 - 20 x 2 1/2” Bolts

(12) Washers

(12) Locknuts

1.

2.

#3 Phillips Head Screwdriver

1.

   a. With the wing on the post facing front, 

align the predrilled holes on front leg to the seat 

and insert the 1/4 - 20 x 2” Bolts through the leg 

in thru the seat. Clean any plastic residue from the 

bolt then slide a washer on. Screw on the locknut 

and then tighten it with the wrench and phillips 

screwdriver.   

b. Align the predrilled holes on the back leg to 

the seat and insert the 1/4 - 20 x 2” Bolts through 

the leg in thru the seat. Clean any plastic residue 

from the bolt then slide a washer on. Screw on the 

locknut and then tighten it with the wrench and 

phillips screwdriver.   

2.

   Place arm rest on top of chair legs align the 

front predrilled holes and insert the 1/4 - 20 x 2” 

Bolts through the leg and in thru the arm. Clean 

off any plastic residue then slide a washer on the 

end of bolt. Screw on the locknut and then tighten 

it with the wrench and phillips screwdriver. 

3.

   a. Attach the back of  the chair to the seat 

by aligning holes and inserting a 1/4 - 20 x 2” 

Bolt then tighten with a phillips screwdriver.
b. Attach the back of  the chair to the arm by 

aligning holes and inserting a 1/4 - 20 x 2 1/2” 

Bolt thru the arm, leg and into the chair back, then 

tighten with a phillips screwdriver.

4.

   Attach the cross braces of  the chair to the 

legs by aligning holes and inserting a 1/4 - 20 x 

2” Bolt through the leg into the cross brace and 

tighten with a phillips screwdriver.

4.

3.