Kenwood TS-2000 Manuale Istruttivo

65

You can store data in the Quick Memory only when
you operate both the main transceiver and the
sub-receiver in VFO mode.

1 Select the frequency, mode, etc. on the main

transceiver or sub-receiver VFO.

2 Press QUICK MEMO [M.IN].

•

Each time QUICK MEMO [M.IN] is pressed,
the current VFO data is written to the Quick
Memory.

Note:  When RIT or XIT is ON, this ON status and the offset will
also be stored.

You can recall a Quick Memory channel only when
you operate both the main transceiver and the
sub-receiver in VFO mode.

1 Press QUICK MEMO [MR].

•

The current memory channel number appears.

•

If there is no data stored in any Quick memory
channel, the data cannot be recalled to the
current VFO, an error beep sounds.

2 Turn the MULTI/ CH control to select a Quick

memory channel (0 to 9).

•

You cannot change memory channels while
transmitting.

3 To exit, press QUICK MEMO [MR] again.

Note:  Memory channels cannot be changed while using the
TF-SET function.

After recalling a Quick memory channel, you can
temporarily change the data without overwriting the
contents of the channel.  You can change the
frequency even when you select OFF in Menu
No. 06B.

1 Press QUICK MEMO [MR].

2 Turn the MULTI/ CH control to select a Quick

memory channel (0 to 9).

3 Change the frequencies and associated data.

4 To store the changed data in the Quick memory,

press QUICK MEMO [M.IN].

This action stores the new data in the current
channel and bumps the old frequency to the
next higher Quick memory channel.

5 To exit, press QUICK MEMO [MR] again.

Note:  Memory channel data can also be changed while using
the TF-SET function.

QUICK MEMORY ➡ VFO TRANSFER

This function copies the contents of the recalled
memory channel to the VFO.

1 Recall a Quick Memory channel.

2 Press [M

s

s

s

s

s

VFO/ MG.SEL].

Note:  Pressing [M

s

s

s

s

s

VFO/ MG.SEL] after temporarily changing the

recalled data copies the new data to the VFO.