Jura Capresso 64701R1 Manuale Utente

5. FACTORY SETTINGS
Each machine leaves the factory with the following settings:
Filter  ..................... NO
Hardness Level  .... 2
Aroma ................... ROBUST
Auto Off  ................ 2 hours after last use
Language  ............. English
Cup Size ………….. OZ.
Rinse ……………… 

4

The Dial is set to 

for coffee and for hot water and 

for

for steam.

6. PREPARING THE MACHINE FOR THE FIRST TIME
• Make sure all accessories, literature and any other items are

removed from the machine and the water tank.

• Make sure the machine sits on an even, flat surface and the

drawer, tray and used coffee container are inserted (Fig 2).

• Plug-in machine.
• Do NOT fill water tank now.

Important: Do not install the Clearyl Water Filter cartridge 
now. It can block the machine.

• Turn the machine on by pressing the ON/OFF button (Fig. 3a).

The display shows 

• Remove water tank, fill with fresh, cold water and replace.

The display shows

The following procedure is only necessary when setting up the
machine for the first time and after the procedure "Emptying
System Before Transport" (chapter 19f).

• Place a cup underneath the frother (Fig. 13) and turn the 

Steam/Water Selector to the Steam / Water symbol Fig 4b). 

. The machine will pump some water 

through the frother and stop automatically. 

. Turn 

the Steam/Water Selector back to the cup symbol. 

.

. Place a cup underneath the Coffee Spout 

(Fig. 1,1) and press the Rinse Button (Fig. 3f). The machine will
pump a bit of hot water through the coffee spouts and will 
stop automatically. 

. You can only brew coffee when 

the display shows 

.

• Open the bean container lid (Fig. 1, 9) and fill with beans 

(Fig. 5) for details see chapter 7.

• Place an empty cup (at least 8 oz.) under the coffee spouts.
• Push the Dial (Fig. 3e). The Dial illuminates and the display 

shows the cup size 

• Push and hold the 1-Cup button until the display reads 

.

The Impressa E starts grinding and will start brewing.
Initially, the grinding chamber may not fill properly with ground
coffee. The machine will start brewing, then interrupt and the
display will show 

. Push the 1-Cup button again.

Discard this first cup of coffee. Your next cup will be perfect. 
Please note: If coffee only comes out of one spout, move the
spout up and down a few times to clear the internal flow.
You are now ready to make coffee.

7. ADDING COFFEE BEANS
• Open the bean container lid (Fig. 1, 9), fill with beans (Fig. 5).

The container holds approx. 220 grams (8 oz.). Close the lid.

Frozen Beans: Thaw for 3 to 4 hours before adding to bean
container. This prevents moisture from seeping into the grinder.

11.