Jasco 24702 Manuale Utente

SPECIFICATIONS

Antenna

Frequency

VHF: 47 MHz～230 MHz

UHF: 470 MHz～870MHz

Amp Gain

VHF: 21 dB ±3dB

UHF: 19 dB ±3dB

O/P Return Loss

< - 6dB

< 2 dB

RF Output Impedance

75 Ohm

Power Adapter

AC120V / DC9V / 200mA (CEC Level IV)

RF Cable

F (Male), Length 180cm x 1, RG-174/U

Power inserter

Frequency range

47 ~ 890MHz

Insertion Loss

< 2dB

DC Input

+ 9 ~ 12V

DC Output

+ 5V

Input connector

F Female

Output connector

F Male

NOTICE

For the best reception, Please check the following conditions.

Keep away from the source of interferences: keep away from heavy power consumption devices, such
as air conditioner, elevator, hair dryer and microwave oven...etc.

Installed as high as possible: In the case of digital terrestrial reception, if there is interruption between
antenna and transmission tower, it will cause the signal loss. Avoid any interruption, the reception will
be better.

Place the antenna near windows when use the antenna in indoor environment. If the Windows screen
is made of metal material, it will become as a signal shielding. Place the antenna away from those
metal material windows screen.

TROUBLE SHOOTING

If you can not get the digital programs as you expect. Please check following conditions:

a. Check the connection. Make sure all the connection is correct.
b. The indoor antenna is an active antenna with built-in amplifier. Please check that you use the

attached power inserter and power adaptor.

c. After you plug in the power adaptor and connect it to the power inserter, you will see the LED

on the power inserter is lighted on.

d. Check the LED on the antenna. When the antenna is powered on, the LED will be lighted on.

Adjusting the direction of antenna to find the best reception angle.

Adjusting the antenna from vertical position to horizontal position, and try different directions.