MPC OM-20000072 Manuale Utente

• CFG MODEM HOST

The MPC modem is preconfigured for auto-answering as a host. It will issue an IP 
address in the range 192.160.200 to 192.160.215, and establish a PPP connection to 
the client. The client must use an Administrator username and password or set up a 
user, see also Section 5.2.3, Configure Client on Page 45.

• ASSIGN: ‘YES’ or ‘NO’ depending on whether or not respectively the IP 

start and stop addresses are assigned automatically. If ASSIGN is 
changed to ‘YES’, then the IP START and IP STOP rows will not be 
editable.

• IP START: Start of address space that the MPC will use to issue 

addresses.

• IP STOP: End of address space.

The CONFIG DIRECT menu allows you to configure the connection with a host computer that is 
connected directly to the MPC via an RS232 cable. Figure 42 shows the CONFIG DIRECT menu.

• CONFIG DIRECT

• MPC: Shows if the MPC is functioning as a client.

• PC COM: The communication parameters for the PPP port.

• PROTO: The network protocol. The two choices are Point-to-Point (PPP) 

or Serial Line Internet (SLIP) Protocol.

• USRNAME: The user name that the MPC will use to ‘sign on’ to the host 

computer. 

• PASSWRD: The password for the above user.

• SOURCE: ‘YES’ or ‘NO’ depending on whether or not respectively the 

IP address is updated automatically. If AUTO IP is changed to ‘YES’, 
then the IP row will not be editable and anything in the IP ADDR row 
will be deleted.

• IP ADDR: The internet protocol (IP) address.

Ì

Í

Ï

Î