Me Inc NumaLink-3.0 Manuale Utente

 

Page 5 of 33 

2.  The monitor cable should be plugged into the video card on the NumaLink computer.  This is usually 

color-coded blue, and has a picture of a monitor next to it. 

3.  The keyboard and mouse cables are color-coded purple and green, respectively.  Plug these into the 

appropriately labeled outlets on the back of the system. 

4.  For modem line cabling setup, please refer to section 5.2. 
5.  Network cables should be plugged into the appropriate network ports.  If your system has two 

separate Ethernet cards, make sure that the cables go to the correct ports.  See Figure 7 for a sample 
interconnectivity diagram.  You may need to contact the Numa, Inc. Technical Support Staff for 
assistance. 

 

 

NOTE Do not plug two network cables into the same Ethernet card.  This includes both 10base2 
(coaxial) and 10/100baseT (CAT5).  Doing so will damage the Ethernet card. 
 

 
Before starting the NumaLink system, check the following: 
 
1.  All the cables on the NumaLink-3.0 system are securely plugged in. (See section ) 
2.  The monitor is turned on. 
3.  The surge suppressor power strip is turned on. 
 
To start the NumaLink-3.0 system, locate the power button on the front of the machine and press it.  The 
computer will begin its boot sequence.   
 
During boot-up, you will not need to take any action.  The NumaLink-3.0 system is designed to 
automatically load any required programs during boot-up.  

Figure 9

 (page 17) shows what your screen 

may look like when the system has fully booted.  Once the NumaLink system has completely started, you 
may begin transferring patient files from the source system. 
 
If your NumaLink-3.0 system is built on Windows 2000 or XP, you will be prompted to press 
CTRL+ALT+DELETE to log on.  The system will ask you for your user name and password.  In most 
cases, the user name is “numa” and the password is “numa”. 
 

 
To shut down (power off) the NumaLink-3.0 system: 
1.  Click on the Start button in the lower left hand corner of the screen. 
2.  Select the Shut Down option from the list. 
3.  Click the circle next to Shut Down to select it, and then click the OK button to power off the 

NumaLink computer. 

 
To reboot the NumaLink-3.0 system: 
1.  Click on the Start button in the lower left hand corner of the screen.  
2.  Select the Shut Down option from the list. 
3.  Click the circle next to the Restart option to select it, and then click the OK button to reboot the 

computer.